
3D Prototype
Construction of a three-dimensional object from a CAD model or a digital 3D model. It can be done in a variety of processes in which material is deposited, joined or solidified under computer control, with material being added together typically layer by layer.

Climatic Chamber (Durability Test)
Chamber testing involves testing and exposing products to various environmental conditions in a controlled setting. Climatic Chamber testing and Thermal Shock testing are part of chamber testing. Climatic Chamber testing is a broad category of ways to simulate climate or excessive ambient conditions exposure for a product or a material under laboratory-controlled yet accelerated conditions.

Meter Calibration
Energy meter calibration is a process required to determine and reduce the error when the energy is measured. The errors in the energy meter can be caused by different sources like voltage transformers, current transformers errors due to phase angle, crystal oscillators, etc.

Laser Marking Machine
Laser marking can mark a variety of materials such as steel, aluminum, stainless steel, polymers, and rubber. It is often used to identify parts and products with 2D barcodes (data matrix codes or QR codes), alphanumerical serial numbers, VIN numbers, and logos.

PCB Design
Printed circuit board (PCB) design brings your electronic circuits to life in the physical form. Using layout software, the PCB design process combines component placement and routing to define electrical connectivity on a manufactured circuit board.

Surge Test
A surge test is the only test that finds weak turn-to-turn insulation. This is due to higher voltages used in a surge test. Low voltage tests do not stress the insulation and consequently dielectric weaknesses are not found. A surge test is the only test that finds weak coil-to-coil and phase-to-phase insulation.